4-22 DATA PLATE AND REFLECTOR MAINTENANCE

Figure 4-21.1. Identification/Transportation Data Plate and Reflector Replacement.

TM-9-6115-659-13P Power Unit PU-732/M (NSN 6115-00-280-3082) MEP-118A 15 Kw 400 Hz Generator Set M200A1 2-Wheel 4-Tire Modified Trailer Manual
Page Navigation
116

TM 9-6115-659-13&P 2. Remove self-locking nuts (7), flat washers (6), screws (5) and mounting plate (10); AN/MJQ-36 only. 3. Remove self-locking nut (9), lock washer (12), flat washer (8), and lifting ring (11) from mounting plate (10). INSTALLATION 1. Install lifting ring (1), flat washer (3) and self-locking nut (4). Set ring at an angle of 35° ± 5° measured from line running from front to rear of trailer. With the aid of an assistant, torque to 315-347 lb-ft (427-470 N•m); AN/MJQ-35 only. 2. Install lifting ring (11), flat washer (8), lock washer (12), and nut (9) on mounting plate (10) and torque to 315-347 Ib-ft (427-470 N•m). 3. Install mounting plate (10), screws (5), flat washers (6), and self-locking nuts (7). 4-22 DATA PLATE AND REFLECTOR MAINTENANCE. This task covers: Replacement INITIAL SETUP Tools Tool Kit, General Mechanic's (item 1, appendix B) Drill, 1/4-inch (item 2, appendix B) Drill, Twist, 3/16 (item 2, appendix B) Riveter, Blind Head (item 5, appendix B) Materials/Parts Plate, Identification/Transportation Data Screws, Drive Rivets (item 3, appendix I) REPLACEMENT Equipment Conditions Reference Trailer handbrakes set, front support leg/landing leg lowered, and rear leveling-support jack lowered; paragraph 2-3.2.1. 1. REPLACE DATA PLATE. NOTE For AN/MJQ-35 and PU-797 data plates refer to trailer chassis TM 9-2330-202-14&P. For AN/MJQ-36 data plates refer to trailer chassis TM 9-2330-213-14&P. For AN/MJQ- 35A and PU-797A data plates refer to trailer chassis TM 9-2330-392-14&P. a. Drill out rivets (4, figures 4-21.1 and 4-22) and remove data plate (3). b. Position data plate (3) on trailer and install rivets (4). Change 2 4-44

Privacy Statement
Press Release
Contact