TM 9-6115-659-13&P
4-19 ACCESSORY BOX MAINTENANCE.
This task covers:
a.
Removal
c.
Installation
b.
Repair
INITIAL SETUP
Tools
Tool Kit, General Mechanic’s
(item 1, appendix B)
1/4-inch Drill
(item 2, appendix B)
Blind Head Riveter
(item 5, appendix B)
Material/Parts
Catch, Clamping and Strike
Rivets, Blind
Material/Parts - continued
Nuts, Self-locking
Hasp
Washers, Lock (item 1, appendix I)
Equipment Conditions
Reference
Trailer handbrakes set, front support leg/landing
leg lowered, and rear leveling-support jack
lowered; paragraph 2-3.2.1.
NOTE
Accessory box mounting hardware for AN/MJQ-35A and PU-797A (plain nuts, lock washers, flat washers,
and cap screws) differs from that used on other power plants and power units, but removal and installation
procedures are similar.
REMOVAL
1.
Release clamping catches (4, figure 4-19) and open accessory box cover (1).
Figure 4-19. Replace Accessory Box.
2.
Remove accessories from accessory box.
Change 2 4-40
