TM 9-6115-659-13&P
2. REPLACE HASP
a.
Drill out rivets (7) on hasp (8).
b.
Install new hasp (8) on accessory box (4) with rivets (7).
INSTALLATION
1.
Position accessory box (1, figure 4-19) over mounting holes in trailer.
2.
Install flat washers (3), machine bolts (2), and self-locking nut (5).
3.
Return accessories to accessory box.
4.
Close accessory box cover and secure with clamping catches (4).
4-20
FIRE EXTINGUISHER BRACKET MAINTENANCE.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools
Tool Kit, General Mechanic’s
(item 1, appendix B)
Materials/Parts
Nuts, Self-locking
Washers, Lock (item 2, appendix I)
Equipment Conditions
Reference
Trailer handbrakes set, front support leg/landing leg
lowered,
and
rear
leveling-support
jack
lowered;
paragraph 2-3.2.1.
NOTE
Fire extinguisher bracket mounting hardware for AN/MJQ-35A and PU-797A
(plain nuts, lock washers, flat washers, and cap screws) differs from that used on
other power units and power plants, but removal and installation procedures are
similar.
REMOVAL
1.
Remove fire extinguisher from bracket.
2.
Remove four self-locking nuts, flat washers, cap screws, and remove fire extinguisher bracket.
INSTALLATION
1.
Install fire extinguisher bracket, four cap screws, flat washers, and self-locking nuts. Tighten self-locking nuts.
2.
Place fire extinguisher in bracket.
Change 2 4-42
