TM 9-6115-659-13&P
a.
Remove self-locking nuts (5, figure 5-21.1), flat washers (6), screws (8), and reflector (7) from trailer (AN/MJQ-35
and PU-797, and rear of AN/MJQ-36 only).
b.
Remove self-tapping screws (2) and reflector (1) from front of trailer (AN/MJQ-36 only).
c.
Install reflector, (7), screws (8), flat washers (6), and self-locking nuts (5) on trailer (AN/MJQ-35 an PU-797, and
rear of AN/MJQ-36 only).
d.
Install reflector (1) and self-tapping screws (2) on front of trailer (AN/MJQ-36 only).
4-23
AN/MJQ-35 TRAILER SPLASH GUARD, BRACKET, AND FENDER MAINTENANCE.
This task covers:
a.
Removal
c.
Installation
b.
Repair
INITIAL SETUP
Tools
Tool Kit, General Mechanic’s
(item 1, appendix B)
Drill, 1/4-inch
(item 2, appendix B)
Materials/Parts
Nuts, Self-locking
Washer, Lock, Split-ring
Covering, Deck
Equipment Conditions
Reference
Trailer handbrakes set, front support leg/landing leg
lowered,
and
rear
leveling-support
jack
lowered;
paragraph 2-3.2.1.
Both generator sets shut down; paragraph 2-5.3.3.
Switch
box
assembly
removed;
paragraph
4-13
(roadside fender only).
REMOVAL
1.
Remove wing nut (13, figure 4-23), two flat washers (14), nut (15), flat washer (16), ground cable (17), and flat washer
(18).
NOTE
If replacing splash guards, ground stud and/or fire extinguisher bracket must be removed
for installation on new splash guard. Perform steps 2 and/or 3. If not, proceed to step 4.
2.
Remove two nuts (19), lock washers (20), internal tooth lock washers (21), and stud (23).
3.
Remove fire extinguisher bracket (paragraph 4-20).
Change 2 4-46
