TM 9-6115-659-13&PNOTEIf replacing splash guards, ground stud and/or fire extinguisher bracket mustbe removed for installation on new splash guard. Perform steps 2 and/or 3. Ifnot, proceed to step 4.4. Remove data plate (paragraph 4-22).5. Remove six self-locking nuts (8, figure 4-23), twelve flat washers (7), six cap screws (12), and splashguard (11).6. Remove three self-locking nuts (5), six flat washers (6), three cap screws (9), and bracket (10).7. Remove six self-locking nuts (2), 12 flat washers (3), six screws (4), and fender (1).REPAIRNOTERepair is limited to replacement of non-skid material (25). Refer to figure G6, appendix G.INSTALLATION1.2.3.4.5.6.7.Install fender (1) to trailer chassis using six cap screws (4), 12 flat washers (3), and six self-lockingnuts (2).NOTEIf new curbside fender is being installed, data plate removed during removalprocedures must be installed. Perform step 2. If not, proceed to step 3.Install data plate (paragraph 4-22).Install bracket (10, figure 4-23) on fender (1) using three cap screws (9), six flat washers (6), and threeself-locking nuts (5).Install splash guard (11) on bracket (10) and mounting rail using six cap screws (12), 12 flat washers(7), and six self-locking nuts (8).NOTEIf new splash guard is being installed, the ground stud and /or fireextinguisher bracket removed during removal procedures must be installed.Perform steps 5 and 6. If not, proceed to step 7.Install fire extinguisher bracket (paragraph 4-20).For roadside splash guard, install ground stud (23), two internal tooth lock washers (21), lock washers(20), nuts (19), and GROUND data plate (22).Install flat washer (18), ground wire (17), flat washer 16), nut (15), two flat washers (14), and wingnut (13).4-48
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
