TM 9-6115-659-13&P
REPAIR
NOTE
Repair is limited to replacement of deck covering (19). Refer to figure G6, appending G.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
Position fender (7, figure 4-25) on trailer chassis and loosely install five cap screws (1), ten flat washers
(2), and five self-locking nuts (3).
Install and tighten ten cap screws (6), twenty flat washers (4), and ten self-locking nuts (5).
Tighten five self-locking nuts (3).
NOTE
If new fender(s) are being installed, fire extinguisher bracket, data plate, ground stud, and
reflectors removed during removal procedures must be installed. If replacing roadside
fender, perform steps 4, 5, and 6. If not, proceed to step 8. If replacing curbside fender,
perform steps 6 and 7.
Install fire extinguisher bracket (paragraph 4-20).
Install ground stud (18), two internal tooth lock washers (16), lock washers (15), nuts (14), and ground
data plate (17).
Install reflectors (paragraph 422).
Install data plates (paragraph 4-22).
Install flat washer (13), ground wire (12), flat washer (11), nut (10), two flat washers (9), and wing
nut (8).
4-52
