TM 9-6115-658-13&P 5-9 Table 5-1.  Relay Board Harness W11 Wire List WIRE LIST TERMINATION TERMINATION WIRE NO. FROM ITEM NO. TO TERMINAL ITEM NO. WIRE ITEM NO. 1 K3-2 TB1-1 54 34 2 K3-3 TB1-6 54 34 3 K3-4 TB1-5 54 34 4 K3-5 TB1-3 54 34 5 K3-6 TB1-4 54 34 6 K3-7 TB1-2 54 34 7 K5-2 TB1-1 54 34 8 K5-3 TB1-8 54 34 9 K5-4 TB1-10 54 34 10 K5-5 TB1-17 54 34 11 K5-6 TB1-6 54 34 12 E-7 E-6 - 34 13 K4-2 TB1-14 54 34 14 K4-3 TB1-9 54 34 15 K4-4 TB1-5 54 34 16 K4-5 TB1-3 54 34 17 K4-6 TB1-7 54 34 18 K4-7 TB1-15 54 34 19 R1-1 TB1-17 54 34 20 K6-3 TB1-12 54 34 21 K6-4 TB1-11 54 34 22 K6-5 TB1-16 54 34 23 K6-6 TB1-13 54 34 24 K6-7 TB1-15 54 34 25 R1-2 E6 - 34 26 R2-2 E3 - 34 27 E5 TB1-1 54 34 28 E4 TB1-2 54 34 29 R2-1 TB1-16 54 34 30 E2 TB1-15 54 34 31 E1 E4 - 34 32 K5-7 TB1-2 54 34 33 E1 TB1-14 54 34 34 E8 TB1-18 54 34 35 K6-2 TB1-14 54 34 36 E9 E3 - 34 NOTE Wire being checked must be disconnected at one location to isolate wire for continuity check. 3.  If any wire fails continuity check, repair or replace relay board harness. 4.  If all wires pass continuity check, install relay board assembly (4), four flat washers (3), lock washers 2) and screws (1).