TM 9-6115-658-13&P
4-42
INSTALLATION
1. Position fender (15, Figure 4-22) on trailer chassis and loosely install five bolts (18), flat washers
(9), and five self-locking nuts (10).
2. Install and tighten bolts (16), flat washers (12), and self-locking nuts (11), with cross brace (17).
3. Install and tighten bolts (8), flat washers (13), and self-locking nuts (14).
4. Tighten five self-locking nuts (18).
NOTE
If new fender(s) are being installed, fire extinguisher bracket, data plate, ground stud, and
reflectors removed during removal procedures must be installed.
5. Install fire extinguisher bracket (paragraph 4-20).
6. Install ground stud (2), flat washer (5), lock washer (6), nut (7), ground cable (1) and ground terminal
data plate (4) using rivets.
7. Install reflectors (paragraph 4-21).
8. Install data plates (paragraph 4-21).
9. Perform the following procedures if replacing curbside fender.
a. Replace fire extinguisher bracket; paragraph 4-20.
b. Replace cable reel assembly; paragraph 4-26.
c. Replace antenna mount and mast support; paragraph 4-25.
d. Remove data plate; paragraph 4-21.
10. Perform the following procedures if replacing roadside fender.
a. Replace accessory box; paragraph 4-19.
b. Replace fire extinguisher bracket; paragraph 4-20.
c. Replace antenna mount and mast support; paragraph 4-25.
