TM 9-6115-658-13&P
4-45
Figure 4-24. Jack, Leveling-Support Repair, 1 Ton Trailer.
2. Assemble trailer rear leveling-support jack.
a. If removed in disassembly, install lubrication fitting (3).
b. Clamp upper leg (1) in a vise with spring pin hole facing up.
c. Insert leg base (4), align hole and install a new spring pin (2).
INSTALLATION
Before removing trailer rear leveling-support jack, support rear of trailer
with jack stands. Failure to observe this warning can cause severe
personal injury or death.
1. Install bracket (7, Figure 4-23) on trailer chassis (1), with flat washer (14) and bolt (13), through mounting hole
in bracket (7) on trailer chassis (1).
2. Install flat washer (2) and a new self-locking nut (3) on bolt (13).
3. Install bolts (9), flat washers (8 and 5), and new self-locking nuts (4).
4. Position leg base (11) and attached parts in bracket (7) and install retaining pin (10).
5. Position leg base (11) and install pivot shaft (15).
6. Install new cotter pin (16 or 6) in pivot shaft (15).
7. Lube rear leveling-support jack.
WARNING
