ARMY TM 9-6115-604-12
NAVY NAVFAC P-8-633-12
CHAPTER 2
OPERATING INSTRUCTIONS
Only properly trained and qualified personnel should operate this equipment. Do
not operate the generator set unless the chassis ground terminal Is connected to a
suitable ground. The generator neutral line is grounded through a transformer for
ground fault protection. The generator neutral line must be grounded. Failure to
comply with this warning could cause loss of life and/or severe damage to
equipment.
SECTION I. OPERATING PROCEDURES
2-1. GENERAL. This section provides Information on how to operate the generator set under normal conditions.
Conditions other than those covered in Section III of this chapter and where the generator set is functioning properly are
considered normal The location and function of the controls and Instruments necessary for operating the generator set
are presented in Figure 2-1 through Figure 2-12 and Table 2-1 through Table 2-12. The purpose of these figures and
tables is to enable the operator to become familiar with these controls and indicators prior to actually operating the
equipment. Take the time to study these figures and tables while inspecting the actual equipment. The knowledge
gained will greatly improve your ability to operate the generator set. The step-by-step operating Instructions for starting
the generator set are presented beginning with Figure 2-13. The operating procedures are followed by detailed
Instructions on how to apply an electrical load to the generator, then by procedures for stopping the set. If equipment
malfunctions, refer to the troubleshooting and maintenance procedures In Chapter 3.
2-2. QUALIFICATION AND LICENSING OF PERSONNEL . Qualification and licensing of operator personnel shall be In
accordance with:
a.
(A) U S Army qualification and licensing shall be In accordance with AR 350-224, TB600-1, and USAFESA
Supplement 1 to TB600-1
b.
(N) U.S. Navy qualification and licensing shall be accomplished by the local commands licensing agency where
the generator unit is deployed
2-3. CONTROLS AND INSTRUMENTS . The purpose, location, and normal operating readings or setting of generator
set controls and instruments are illustrated in Figure 2-1 through Figure 2-12 and described in Table 2-1 through Table 2-
12.
2-1
