Figure 15-7. Transducer A107 and A108, Test Setup

Figure 15-6. Transducer A103, Test Setup

Figure 15-8. Annunciator Control Assembly A20 (Sheet 1 of 2)

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
298

TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Figure 15-7. Transducer A107 and A108, Test Setup b. Repair. If any of the relays or diodes are defective, Annunciator Control Relay Assembly A20 is repairable by replacing the defective component. If the printed circuit wiring or a terminal board proves defective, or a non-replaceable component is defective, the entire assembly must be replaced. c. Replacement. (1) Remove annunciator (13, figure 15-3) as follows: (a) Tag and then disconnect wires from terminal boards. (b) Remove screws (10) and nuts (11) to remove annunciator (13) and brackets (12). (c) Components are replaced by carefully unsoldering them from the printed circuit board. CAUTION Do not apply excessive heat when soldering or unsoldering components. It may damage the printed circuit wiring. (d) If Annunciator Control Relay Assembly is to be replaced, remove screws (8) and nuts (9) to release annunciator (13) from brackets (12). (e) Prepare annunciator (13) for installation by attaching brackets (12) using screws (8) and nuts (9). (f) If components are being replaced, carefully solder new component into place. 15-9

Privacy Statement
Press Release
Contact