TM5-6115-593-34
NAVFAC P-8-631-34
TO-35C2-3-463-2
Figure 13-3. Speed Switch Test (Electronic Type) (Code B)
assembly, the ether lines and lubricating oil bypass filters
must first be removed.
a.
Removal.
(1)
Remove six screws
securing ether line support clamps to
engine, then loosen ether line fittings
from manifolds and solenoid valve
(located on upright support) to
remove ether lines. Store ether lines
in a safe place to avoid damaging
them.
(2)
Disconnect lubricating
bypass oil filter hose couplings from
tee on oil pan.
(3)
Disconnect bypass oil
filter inlet hose coupling at top of rear
bypass oil filter, then remove six
screws securing bypass oil filter
support bracket to engine block to
remove bypass oil filter assembly.
(4)
Remove starter by
removing
13-5
