Figure 11-10. Obtaining Dimension C

Table 11-1. Repair of Generator Components

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
141

TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Figure 11-10. Obtaining Dimension C unusual noises such as produced by parts rubbing together. (i) When generator installation has been completed and inspected, install covers and guards. c. Repair. Repair of the generator consists of testing, removing, replacing, and repairing components as listed in table 11-1. (1) Replace or rebuild all defective parts. NOTE To remove coils from an iron core, it is recommended that the part be heated in a moderate oven temperature 302°F (150°C) to facilitate removal. Single coils should not be replaced as adjacent parts of the winding may be damaged during, coil removal. (2) Apply varnish to any damaged areas of insulation. (3) Replace damaged exciter rotor or stator. d. Overhaul. Overhaul of the generator consists of the 11-19

Privacy Statement
Press Release
Contact