Figure 11-9. Obtaining Dimension Y

Figure 11-8. Checking Flywheel Housing Runout

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
140

TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Figure 11-9. Obtaining Dimension Y (b) Install permanent magnet rotor (37, figure 11-3) with spring pin (36), cover (30), bolt (34), and washer (35). (c) Install permanent magnet stator (33) with screws (31) and washers (32). (d) Install cover (30) with screws (26 and 28), washers (29) and nuts (27). (e) Connect (+) and (-) leads from generator field onto (+) and (-) terminals located on the heat sinks of the rotating rectifier assembly. (f) Before placing generator set in operation, visually inspect clearance between generator stationary and rotating parts. (g) Visually inspect alignment of the exciter armature with the exciter field. (h) Before placing generator set in operation, turn engine through several revolutions, but do not permit engine to start. visually inspect clearance between generator stationary and rotating parts. Listen for 11-18

Privacy Statement
Press Release
Contact