TM 5-6115-585-34NAVFAC P-8-623-34TO 35C2-3-455-2TM-05684C/05685B–34shutter assembly (15) with four screws (17), eight washers (18and 19), and four locknuts (20) (listed in table 10-1, item 7).(5)Torque screws (17) to 16 ±2 ft-lbs dry.(6)Route drain hose (11) between batteries andengine block.g.Right Panel Assembly (Long Side).(1) Refer to figure 10-5 and clear out acoustic fillfrom holes in right panel assembly (1) using 3/8 inch diameterpin.(2)Locate right panel assembly (1) on right supportassembly (2) by aligning captive nuts (3) in right panel assembly(1) with holes in right support assembly (2). Align captive nuts(4) in rear panel assembly (5) with holes in right panel assembly(1) .Align holes in right panel assembly (1) with holes in rearclosure assembly (6).(3)Install right panel assembly (1) to right supportassembly (2), with five screws (7) and five washers (8). Installright panel assembly (1) to rear closure assembly (6) with twoscrews (9), four washers (10 and 11) and two locknuts (12).Install right panel assembly (1) to rear panel assembly (5) withtwo screws (13) and two washers (14) (as listed in table 10-1,item 9).(4)Torque screws (7) and screws (13) to 18 ±2 in.-lbs dry.(5)Torque screws (9) to 16 ±2 ft-lbs dry.h.Side Closure Assembly.NOTESide closure assembly is installed attachedto left panel assembly.i.Left Panel Assembly (Short Side) with Side ClosureAssembly.(1)Remove battery connection instruction plate moun-ted next to batteries by breaking off rivet heads with hammer andchisel .Clean underside of plate.Refer to figure 10-6 and reinstall plate (1) on left panel assembly (2) at locationshown with double sided tape (as listed in Table 10-1, item 8).(2) Refer to Figure 10-6, detail A, and installbattery terminal covers (3).Disconnect cable clamps frombattery terminals.Place 4 each terminal covers (3) over battery10-12Change 6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
