TM 5-6115-585-34NAVFAC P-8-623-34TO 35C2-3-455-2TM–05684C/05685B–34(4)Cut a 61 in. length of adhesive backed teflontape (as listed in Table 10-1, item 1).Apply adhesive backedteflon tape to a clean right support assembly top surface(surface that mounts against underside of skid frame). Use handpressure to remove air bubbles.Clear teflon tape away fromscrew slots.(5)Loosen four existing screws (4) and slide rightsupport assembly (1) between skid (2) and bevel washers (6), asshown in figure 10-1, detail A.(6)Install two each screws (7), washers (8), bevelwashers (9), lockwashers (10) and nuts (11) (as listed in Table10-1, item 1) in the two additional mounting holes (5).(7)Torque four existing screws (4) and the two addedscrews (7) to 26 ±2 ft-lbs dry.(8) Refer to Operator and Organizational MaintenanceManual, paragraph 3-24 and reinstall engine lifting bracket,shroud and blower housing.b.Left Support Assembly.(1)Refer to figure 10-3 to remove four screws (1)and lockwashers (2) securing access plate (3) to AC outputcontrol box assembly (4).(2) Cut a 61 in. length of adhesive backed teflontape (as listed in Table 10-1, item 2).Apply adhesive backedteflon tape to a clean left support assembly (5) top surface(surface that mounts against underside of support frame).Usehand pressure to remove air bubbles.Clear teflon tape away fromscrew slots.(3)Loosen four existing screws (6) and slide leftsupport assembly (5) between skid (7) and bevel washers (8) asshown in figure 10-3, detail A.(4)Torque four existing screws (6) to 26 ±2 ft-lbsdry.(5)Refer to figure 10-3 to install four screws (1)and lockwashers (2) which secure access plate (3) to AC outputcontrol box assembly (4).c.Rear Panel Assembly.Change 610-7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
