TM  5-6115-585-34 NAVFAC  P-8-623-34 TO  35C2-3-455-2 TM–05684C/05685B–34 SECTION  II. ACOUSTIC  SUPPRESSION  KIT  INSTALLATION 10-2. ACOUSTIC  SUPPRESSION  KIT. The 10K Acoustic Suppression Kit (ASK) is installed on generator sets in either the skid or trailer configuration. For the trailer mounted configuration, the ASK is installed on the trailer at the approximate location shown in figure 10-1. Table .0-1 lists ASK parts and related hardware. All  required  mounting hardware is supplied with the modification kit. Locate  ASK assemblies, drill mounting holes and assemble as described in the following  paragraphs. Table  10-1. Acoustic  Suppression  Kit  Parts  and Required  Hardware Item Assembly Related  Hardware Qty 1.   Right  Support (1, fig. 10-2) 2. Left Support (5, fig. 10-3) Rear Panel (14, fig. 10-2) 3. 4. Rear  Flap (19, fig. 10-2) 5. Rear  Closure (1, fig. 10-4) 6. Side  Closure 3/8"-l6xl-1/4LG Hex Cap Screw 3/8” Washer 3/8” Nut 3/8”  Lockwasher 3/8” Bevel Washer Adhesive  Backed  Teflon Use  existing  Hardware Adhesive  Backed  Teflon l/4"-20x3/4LG Hex Cap Screw 1/4” Washer 1/4” Locknut Adhesive  Backed  Teflon l/4-20x3/4LG Hex Cap Screw 1/4” Washer 1/4” Locknut l/4"-20x3/4LG Hex Cap Screw 1/4” Washer 1/4” Locknut Adhesive  Backed  Teflon l/4"-20x3/4LG 2 2 2 2 2 Tape 61 in. 4 Tape 61 in. 4 8 4 Tape 11 3/4 in. 3 6 3 4 8 4 Tape 23 in. 14 in. (4, fig. 10-6) Hex Cap Screw 2 1/4” Washer 4 1/4” Locknut 2 Adhesive  Backed  Teflon  Tape 20 1/2 in. 29 1/4 in. 10-2 Change 6