TM 5-6115-585-34NAVFAC P-8-623-34TO 35C2-3-455-2TM–05684C/05685B–34CAUTIONWhen drilling holes, care must be taken notto damage fuel lines.(1)Refer to figure 10-2, detail B and drill one 5/16inch guide hole (12) in generator set control cubicle supportframe (13) at location shown.(2)Using rear panel assembly (14) as template, aligndrilled guide hole (12) with bottom left rear panel assembly holeand mark location of three remaining holes in generator set con-trol cubicle support frame (13).Drill three 5/16 inch holes.(3)Cut a 11 3/4 in. length of adhesive backed teflontape (as listed in Table 10-1, item 3).Apply adhesive backedteflon tape to a clean right side surface of rear panel assembly(14) (surface with 2 captive nuts).Use hand pressure to removeair bubbles.Clear tape from captive nut openings.(4)Refer to figure 10-2 to install rear panel as-sembly (14) to generator set control cubicle support frame (13)with four screws (15) , eight washers (16 and 17) and fourlocknuts (18) (listed in table 10-1, item 3) .(5)Torque screws (15) to 16 ±2 ft-lbs dry.d.Rear Flap Assembly.(1)Refer to figure 10-2 and using rear flap assembly(19) as template, center assembly on skid, resting rear flap as-sembly angle on top of skid (2).Mark mounting hole locationsand drill three 5/16 inch holes (20) into skid (2).(2)Install “rear flap assembly (19) to skid (2) withthree screws (21), six washers (22 and 23) and three locknuts(24) (listed in table 10-1, item 4).(3)Torque screws (21) to 16 ±2 ft-lbs dry.e.Rear Closure Assembly.(1)Refer to Operator and Organizational MaintenanceManual paragraph 3-18 and remove air cleaner assembly.Change 610-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
