Front Panel Assembly - TM-5-6115-585-34

Figure 10-6. Installation of Left Panel, Side Closure, Front Panel and Top Panel Assemblies

Top Panel Assembly - TM-5-6115-585-34_182

TM-5-6115-585-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
147

TM 5-6115-585-34 NAVFAC P-8-623-34 TO 35C2-3-455-2 TM-05684C/05685B–34 terminals; 2 red terminal covers for positive battery terminals and 2 black terminal covers for negative battery terminals (as listed in Table 10-1, item 8). Reconnect cable clamps to battery terminals. Cover cable clamps with terminal covers (3). (3) Clear out acoustic fill from holes in left panel assembly (2) using 3/8 inch diameter pin. (4) Cut a 20 1/2 in. length and a 29 1/4 in. length of adhesive backed teflon tape (as listed in Table 10-1, item 6). Apply adhesive backed teflon tape to a clean top edge (surface which will mount against top panel assembly) and left edge (edge with three holes) of side closure assembly (4). Use hand pressure to remove air bubbles. Clear teflon tape away from screw holes. (5) Install left panel assembly (2) to side closure assembly (4) with three screws (5), six washers (6 and 7) and three locknuts (8) (as listed in table 10-1, item 8.b). (6) Torque screws (5) to 16 ±2 ft-lbs dry. (7) Locate left panel assembly (2) (with side closure assembly (4) attached) on left support assembly (9) by aligning captive nuts (10) in panel with holes in left support assembly (9) . Align side closure assembly mounting holes (11) with rear closure assembly mounting holes (12). (8) Install left panel assembly (2) with side closure assembly (4) to left support assembly (9) with four screws (13) and four washers (14) and to rear closure assembly (15) with two screws (16), four washers (17 and 18) and two locknuts (19) (as listed in table 10-1, item 8.a. and item 6). (9) Torque screws (13) securing left panel assembly (2) to left support assembly (9) to 18 ±2 in.-lbs dry. (10) Torque screws (16) securing side closure assembly (4) to rear closure assembly (15) to 16 ±2 ft.-lbs dry. j. Front Panel Assembly (1) Refer to figure 10-6 and clear out acoustic fill from holes in front panel assembly (20) using 3/8 inch diameter pin. (2) Install front panel assembly (20) to right panel assembly (21) and left panel assembly (2) with six screws (22) and six washers (23) (as listed in table 10-1, item 10). Start all screws by hand first. (3) Torque screws (22) to 18 ±2 in.-lbs dry. Change 6 10-15

Privacy Statement
Press Release
Contact