1. Screw2. Flywheel assy3. Ring gear4. Flywheel5. Wear sleeve6. Plug7. Screw8. Washer9 . O i l s e al10. Preformed packing11. Preformed packing12. HousingME 6115-545-34/14-33Figure 14-33. Flywheel and HousingNOTEFinal installation of the flywheel intothe seal is blind, therefore, extremecare must be exercised to preventcrimping or cutting the sealing lipof the seal when installing the fly-wheel.g.Install flywheel housing on cylinder blockand tighten securing capscrews to a torque of73 foot-pounds.Install oil pan capscrews to fly-wheel housing and tighten them to a torque of 28 to33 foot-pounds.h.Press new wear sleeve onto flywheel flange.DO not use lubricant or sealer Metal-to-metal con-tact is necessary for proper heat transfer.seal on until its shoulder makes contact with the fly-NOTEstart ring gear on the flywheel sothat when the flywheel is installed,the chamfered ends of the teeth willface the cylinder block.i .Install the ring gear onto the flywheel byUniformly heating the gear to 300° F (dull red heatvisible in the dark).Then, press ring gear onto theflywheel which is at room temperature.NOTEDO not overheat the ring gear to abright red. This will destroy thetemper of the gear.j .Drive gear down tight against the shoulderof the flywheel.Allow the ring gear to cool slowly,do not cool with water.wheel.Change 114-71
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
