Figure 3-17. Generator Set Controls

TM-5-6115-545-12 Power Unit Utility Pack Gas Turbine Engine Driven (Air Research Model PPU85-5) Non-Winterized and (Air Research Model PPU85-4) Winterized Manual
Page Navigation
122

1. Wiring harness 8. 2. Wiring harness 9. 3. Screw 10. 4. Nut 11. 5. Clamp 12. 6. Wiring harness 13. 7. Control cubicle 13A. assembly 14. Blank panel Blank panel Fault indicator panel Screw Cover(Class 1 sets) Screw, stop lever Throttle lever assembly (Deleted) 15. (Deleted) 16. Nut 17. Washer 18. Nut 19. Nut 20. Washer 21. Manual control assembly Figure 3-17. Generator Set Controls (2) Unscrew fuse holder cap (24) and remove fuse (25). Install new fuse and replace fuse holder cap (24). 3-104. Control Cubicle Assembly. See figures 3-18, 19 and 20, and proceed as follows: a. Inspection. Inspect the generator control cubicle for defective, broken, cracked, or otherwise defective components. b. Testing. Testing of components of the control cubicle is described under the appropriate heading in paragraphs 3-105 through 3-130. c. Repair. Repair by replacement of components which do not function properly during testing. C h a n g e 1 22. Lens 23. Lamp 24. Fuse holder cap 25. Fuse 26. Test or reset switch 27. Dc control circuit breaker CAUTION Turn engine off and remove the battery negative connection be- fore removing any electrical leads to avoid possible short circuit and resulting damage. d. Replacement. If a component needs replace- ment, gain access to the rear of the control cubicle panel (96, fig. 3-18) by loosening the three quarter- turn fastener and permitting the control cubicle panel to pivot about its hinges in a forward direction. Re- place control cubicle panel components which do not function properly in step b (testing) as indicated in following paragraphs. Replace control box (123, fig. 3-18) as described in paragraph 3-135 b. 3 - 3 8

Privacy Statement
Press Release
Contact