TM 5-6115-400-35
Figure 51. Rocker arm assembly.
Caution
(2) Lubricate valve lifters with clean oil and
When removing valve lifter bracket,
install lifters and lifter brackets by a direct
reversal of removal procedure. Tighten
use care to prevent valve lifter
the lifter bracket attaching capscrews to a
bracket hollow dowels from falling
torque of 68-73 ft. lbs. and lock with
into the oil pan.
locking wire.
(4) Inspect flat surface of valve lifters for
(3) Install push rods with cup end to the top.
wear and replace any worn valve lifters.
Make certain push rods are seated
b. Installation.
properly in the valve lifters.
(1) The valve lifter brackets are marked
"FRONT" and "REAR" and must be
installed in their proper locations.
