TM 5-6115-400-12
CHAPTER 3
OPERATOR'S AND ORGANIZATIONAL MAINTENANCE
INSTRUCTIONS
Section I. OPERATOR'S AND ORGANIZATIONAL MAINTENANCE
TOOLS, AND EQUIPMENT
3-1. Tools and Equipment
3-2. Organizational Maintenance Repair Parts
The special tools required to perform organizational
Organizational Maintenance repair parts are listed
References indicating the use of these tools are listed in
and illustrated in TM 5-6115-400-25P (when printed).
the table.
Tools and repair parts issued with or
authorized for the generator set are listed in the Basic
Section II. LUBRICATION
3-3. General Lubrication Information
b. The lubrication order shown in figure 3-1 is an
exact reproduction of the approved lubrication order for
a. This section contains a reproduction of the
lubrication order and lubrication instructions which are
supplemental to, and not specifically covered in the
lubrication order.
Table 3-1. Special Tools.
Reference
FSN or
Item
Part Number
Figure
Paragraph
Use
Baring lever
(09367)
3-56
Bar engine over for valve adjustments.
4444698
Wrench
(13786)
Tighten load terminal nuts.
6004
from dust or dirt, and replace covers as soon as
3-4. Detailed Lubrication Information
lubricant is applied.
lubricating equipment clean and free from foreign
b. Foreign Material or Dirt in the Lubricating
material. Open containers only in protected areas free
System. Operating the engine with contaminated oil,
from dust and dirt. Clean grease guns, containers, and
under the assumption that the oil filter will remove any
applicators with cleaning solvent and thoroughly dry
before using. Wipe all caps, cover, plates parts and
quite costly. Actually, there are certain conditions under
surrounding surfaces with clean rags and solvent before
which, if the oil filter is bypassed and if the
removing them to apply lubricants. Protect all openings
3-1