TM 9-6115-668-13
CAUTION
Using a suitable device support the silencer during removal.
a. Remove four nuts (11) and four serrated lock washers (12) while holding four screws (16).
b. Remove four screws (16) from flange and bottom plate of base frame (2).
c. Remove nut (51), serrated lock washer (50), and washer (49).
d. Remove nut (39), serrated lock washer (38), and washer (37).
e. Remove nut (27), serrated lock washer (26), washer (25), and connector pipe (15), elbow (46),
and fasteners (40 to 45, 47, 48, 29 to 36, 17 to 24) and seal (14).
f. Remove silencer assembly (28) from base frame (2)
4.
Remove connector pipes and brackets:
a. Remove washer (48) and nut (47) from holder (42).
b. Hold screw (40) and remove nut (45), serrated lock washer (44), washer (43), nut (47) and
holder (42).
c. Remove screw (40) and washer (41).
d. Remove washer (37) and nut (35) from holder (31).
e. Hold screw (29) and remove nut (34), serrated lock washer (33), washer (32), and holder (31)
with nut (35).
f. Remove screw (29) and washer (30).
g. Pull endpipe (46) off silencer (28).
5.
Remove exhaust pipe with header:
a. Loosen locknuts, turn screws on heat shield over header at turbocharger outlet a few turns, push
angle bracket to one side and loosen heat shield.
b. Remove nuts (9) and washers (8).
c. Pull exhaust pipe with header (10) and gasket (4) off turbocharger outlet. Discard gasket (4).
d. Remove gasket (13) and discard.
CAUTION
Close off turbocharger outlet with cover.
6.
Remove heat shielding tape (6) from exhaust pipe with header (10):
a. Remove clamps (5, 7) from exhaust pipe with header (10) and set aside for re-use.
4-206
