TM 9-6115-668-13
b. Unwrap heat shielding tape (37) from exhaust pipe with header (34).
WARNING
This task requires three persons: some parts weigh up to 66.15
pounds (30 kg).
1.
Apply heat shielding tape (37) to exhaust pipe with header (34):
a. Wrap heat shielding tape (37) over exhaust pipe with header (34) with overlapping turns, starting
from the header.
b. Secure heat shielding tape (37) with clamps (36, 38).
2.
Install exhaust pipe with header (34):
CAUTION
Remove cover from turbocharger outlet.
NOTE
Use new gaskets.
a. Install new gasket (35) on turbocharger outlet and press on exhaust pipe with header (34).
b. Install screws (29) between bottom plate of base frame (2) and exhaust pipe with header (34).
c. Install four washers (39) and four nuts (40) on threaded pins and tighten four nuts (40).
d. Position heat shield and angle bracket over header, and tighten heat shield screws and locknuts.
3.
Install connector pipes and brackets:
a. Install endpipe (22) on silencer (25).
b. Install screw (24) and washer (23) through clamp and put holder (18) in place.
c. Install washer (21), serrated lock washer (20), and nut (19). Tighten nut (19).
d. Install elbow (28) onto silencer (25).
e. Install screw (27) and washer (26) through clamp and put holder (9) in place.
f. Install washer (10) and serrated lock washer (11) and nut (12). Tighten nut (12).
4.
Install silencer assembly, left side:
a. Install nuts (8, 17) and washers (7, 16) on brackets (9, 18) through holes in bottom plate of base
frame from below.
b. Install washer (6), serrated lock washer (5) and nut (4). Do not tighten nut (4).
c. Install washer (15), serrated lock washer (14), and nut (13). Do not tighten nut (13).
d. Install screws (29) through flange and bottom plate of base frame (2).
e. Install four serrated lock washers (32) and four nuts (33). Tighten nuts (33)
4-202