4.81 FUEL LEVEL SENSOR 2R4 MAINTENANCE.

2. Noting correct labeling and position, install cable

TM-9-6115-668-13 5Kw 28VDC Auxiliary Power Unit (APU) MEP 952B Manual
Page Navigation
301

TM 9-6115-668-13 4.81 FUEL LEVEL SENSOR 2R4 MAINTENANCE. This task covers: a. Removal b. installation Tools Equipment Conditions General Mechanic’s Tool Kit Reference (item 2, appendix B) Generator Set 150 kW shut Automotive Fuel and Electrical System Repair, Tool Kit down, (item 3, appendix B) paragraph 2.5.2 Crimping tool (item 26, appendix B) Materials/Parts Hylomar (item 15, appendix E) WARNING Disconnect the negative battery cable first and then the positive bat- tery terminal cables. Failure to observe this warning could result In severe personal Injury or death. WARNING The fuel in this Generator Set 150 KW Is highly explosive. Do not smoke or use open flame when performing maintenance. Fire and ex- plosion could occur, resulting In severe personal Injury or death. 1. Remove unit hood assembly (1, figure 4-62) as instructed in paragraph 4.14. 2. Record labeling and position of cables (27, 32) on fuel level sensor 2R4 (26). 3. Remove screws (29, 30), serrated lock washers (28, 31) and cables (27, 32) from fuel level sensor 2R4 (26). 4. Remove four screws (35), four serrated lock washers (34), four washers (33) and fuel level sensor 2R4 (26) out of fuel tank (36) and remove seal (25). CAUTION Apply Hylomar to seating surface of fuel level sensor. 1. Install seal (25), fuel level sensor 2R4 (26), four washers (33), four serrated lock washers (34), and four screws (35) on fuel tank (36). 4-197

Privacy Statement
Press Release
Contact