TM 9-6115-668-13
7.
Install seven screws (45), seven serrated lock washers (44). and seven washers (43).
NOTE
Apply Hylomar to seating surfaces of fuel level switches (38, 37).
8.
Install upper fuel level switch (36) and lower fuel level switch (37) as instructed in paragraph 4.79
and 4.80.
9.
Noting correct labeling and position, install cables to terminal strip 2X50, (10, figure 4-62).
10. Install rubber sealing strip (50, figure 4-61) on fuel tank (49).
11. Install fuel level sensors (54) as instructed in paragraph 4.76.
12. Install plug connector 2J2 (61) on electrical fuel pump (60).
13. Install EHG regulator N7 as instructed in paragraph 4.76.
14. Install battery charging alternator regulator N6 as instructed in paragraph 4.75.
15. Install air filter as instructed in paragraph 5.27.
CAUTION
Collect any fuel that leaks out.
Apply Loctite 243 to nipples and immersion tubes when inserting.
Reinstall fuel lines as tagged during removal.
Wall new sealing rings.
16. Install nipple (7) and new sealing ring (8).
17. Install hollow screw (3), new sealing ring (4), fuel return line (5), new sealing ring (6), nipple (10),
and sealing ring (9).
18. Install hollow screw (14), new sealing ring (13), fuel leakage line (12), new sealing ring (11), immer-
sion tube adapter (19), new sealing ring (20).
19. Install hollow screw (15), new sealing ring (16), fuel supply line (17), new sealing ring (18), nipple
(22), new sealing ring (20).
20. Install hollow screw (26), new sealing ring (25), fuel return line (24), new sealing ring (23), immer-
sion tube adapter (31), new sealing ring (32).
21. Install hollow screw (27), new sealing ring (28), fuel supply line (29), new sealing ring (30).
22. Using cable ties bundle fuel lines as shown in figure 4-62.
23. Remove fuel hose from delivery side of fuel pump (60).
24. Slide fuel hose (52) onto delivery side of fuel pump (66) and tighten damp (53).
25. Slowly remove fuel hose (38) out of filler neck (33) and hang on bracket (46).
26. Install electrical fuel pump (60) as instructed in paragraph 4.78.
27. Install unit hood assembly (1) as instructed in paragraph 4.14.
4-190
Change 1