TM 9-6115-668-13
12. Remove hollow screw (14), sealing ring (13), fuel leakage line (12), sealing ring (11), nipple (10),
and sealing ring (9). Discard sealing rings (9, 11 and 13).
13. Remove hollow screw (15), sealing ring (16), fuel supply line (17), sealing ring (18), immersion tube
adapter (19), and sealing ring (20). Discard sealing rings (16, 18 and 20).
14. Remove hollow screw (26), sealing ring (25), fuel return line (24), sealing ring (23), nipple (22), and
sealing ring (21). Discard sealing rings (21, 23 and 25).
15. Remove hollow screw (27), sealing ring (28), fuel supply line (29), sealing ring (30), immersion tube
adapter (31), and sealing ring (32). Discard sealing rings (28, 30 and 32).
16. Remove air filter as instructed in paragraph 5.27.
17. Remove battery charging alternator regulator N6 as instructed in paragraph 4.75.
18. Remove EHG regulator N7 as instructed in paragraph 4.76.
19. Record labeling and position of cables and disconnect cables from terminal strip 2X50 (10, figure
4-62) and grounding cables (12, 13 and 22).
20. Remove plug connector 2J2 (61, figure 4-61) from electrical fuel pump (60).
21. Remove fuel level sensor (54) as instructed in paragraph 4.81.
22. Remove rubber sealing strip (50) from fuel tank (49).
23. Remove upper fuel level switch (36) and lower fuel level switch (37) as instructed in paragraph 4.79
and 4.80.
24. Remove seven screws (45), seven serrated lock washers (44), and seven washers (43).
25. Remove screw (41), serrated lock washer (40, and washer (39).
26. Place sling around fuel tank (49) and attach to lifting device.
This procedure requires the aid of an assistant. Stay clear of the sus-
pended load. Failure to observe this warning could result in severe
personal injury or death.
27. Lift fuel tank (49) off base frame (2) and place on a flat surface or support blocks.
28. Remove serrated lock washer (42) from base frame (2).
1.
Place sling around fuel tank (49) and attach to lifting device.
2.
Lift fuel tank (49) off the flat surface or support blocks, and position over base frame (2).
CAUTION
Provide a ground connectton between the fuel tank and the base
frame.
3.
Install serrated lock washer (42) on base frame (2).
4.
Lower fuel tank (49) onto base frame (2).
5.
Remove sling from lifting device and fuel tank (49).
6.
Install screw (41), serrated lock washer (40, and washer (39).
4-189