TM 9-6115-668-137.Unlock lamp cap (14) and housing (15) with sealing ring (16) from front of front panel by turningcounterclockwise.8.Pull lamp cap (14) and housing (15) with sealing ring (16) out of front of front panel (4) and removebase (18) from back of front panel (4).N O T EThe diode holders next to light indicator assembly H2 to H4 (10 to 12)are to be removed separately.9.To remove diode holders next to light indicator assembly H2 to H4 (12 to 10), perform steps 1 to 5.INSTALLATIONCAUTIONReinstall the same type of bulb holder that was removed.NOTEThe procedure for removing light indicator assembly H103 (6), H102(7), H17 (8), H15 (9), H4 (10), H3 (11), H2 (12) is the same as for light indi-cator assembly H1 (13), described below.1.Install housing (15), sealing ring (16) and lamp cap (14) into front panel (4) from the front and holdbase (18) against front panel (4) from the rear.2.Push lamp cap (14), housing (15) and sealing ring (16) into base (18) and turn clockwise to secureto base (18).3. Tighten screws (19) on base (18).4.Clip bulb holder (21) with bulb (17) into base (18).5.Connect cables to terminals (22, 23) of bulb holder (21), noting correct labeling and position.N O T EThe diode holders next to light indicator assembly H2 to H4 (10 to 12)are to be installed separately.6.To install diode holders next to light indicator assembly H2 to H4 (12 to 10), perform steps 1 to 5.7.Stow prop (5) and close front panel (4).8. Close flap (2).4 - 6 0
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
