TM 9-6115-668-13
4.25 BULB IN ILLUMINATED SWITCH MAINTENANCE.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Tool Kit
Reference
(item 2, appendix B)
Generator Set 150 kW shut
Automotive Fuel and Electrical System Repair, Tool Kit
down, paragraph 2.5.2
(item 3, appendix B)
Suitable Bulb Removal Tool (Sec IV, Reference code R, ap-
pendix B)
REMOVAL
N O T E
This procedure is the same for lamp H5 (2), H8 (7), H9 (6), H10 (5), H11
(3), H12 (8), H14 (10), H16 (9), and H101 (11) (figure 4-31).
1.
Open flap (1, figure 4-31).
2.
Remove collar (12) by unscrewing from lamp housing (15).
3.
Remove lens (13) by unscrewing from lamp housing (15).
4.
Using a suitable bulb removal tool, push bulb (14) in, turn bulb (14) counterclockwise, and remove
bulb (14) from lamp socket (16).
INSTALLATION
1.
Install bulb (14) in lamp socket (16), using the suitable bulb tool, by pushing the bulb (14) in and
rotating the bulb (14) clockwise.
2.
Install lens (13) on lamp housing (15).
3.
Install collar (12).
4.
Close flap (1).
4-64
