TM 9-6115-668-134.26 REPLACE BULB IN PANEL LIGHT H6.This task covers:a. Removalb. InstallationINITIAL SETUPToolsEquipmentConditionsGeneral Mechanic’s Tool KitReference(item 2, appendix BGenerator Set 150 kW shutAutomotive Fuel and Electrical System Repair, Tool Kitdown, paragraph 2.5.2(item 3, appendix BREMOVALN O T ERemoval procedure for the three H6 panel lights is identical to this ex-ample.1.Open flap (1, figure 4-32).2.Remove cover (2) by grasping cover (2) firmly and pulling off lamp base (3).3.Loosen set screws (6) on terminal, and remove wire (7).4.Pull lamp socket (5) and bulb (4) to the right and slide off lamp base (3).5.Push down on bulb (4) in lamp socket (5), turn counterclockwise, and pull out.INSTALLATION1.Insert bulb (4) into lamp socket (5).2.Push down on bulb (4), turn clockwise until it stops, then release.3.Install bulb (4) with lamp socket (5) in lamp base (3), and push in until seated.4.Attach cable (7) to terminal and tighten set screw (6).5.Install cover (2) on lamp base (3) and push to secure.6. Close flap (1).4 - 6 6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
