TM 9-6115-660-13&PREMOVALRemove four self-locking nuts (1, figure 4-23), eight flat washers (2), four screws (3), and trailerplatform (4).INSTALLATIONInstall platform (4), four screws (3), eight flat washers (2), and four self-locking washers (1).4-24 PU-789 AND PU-799 FENDER MAINTENANCE.This task covers: a. Removalc. Installationb. RepairINITIALSETUPToolsEquipmentConditionsTool Kit, General Mechanic’s(item 1, appendix B)ReferenceDrill, l/4-inch(item 2, appendix B)Trailer handbrakes set, front supportleg/landing leg lowered, and rearleveling-support jack lowered; paragraphMaterials/Parts2-3.2.1.Nuts, Self-lockingBoth generator sets shut down; paragraphWasher, Lock, Split-ring2-5.3.3.Covering, DeckREMOVAL1. Remove wing nut (8, figure 4-24), two flat washers (9), nut (10), flat washer (11), ground cable (12), andflat washer (13).NOTEIf fender is being replaced, fire extinguisher bracket, data plate, ground stud,and reflectors must be removed and retained for installation on new fender. Ifreplacing roadside fender, perform steps 2, 3, 5, and 6. If replacing curbsidefender, perform steps 4, 5, and 6.2. Remove two nuts (14), lock washers (15), internal tooth lock washers (16), and ground stud (18).3. Remove fire extinguisher bracket (paragraph 4-20) and reflectors (paragraph 4-22).4. Remove data plate and reflectors (paragraph 4-22).5. Remove ten self-locking nuts (5), twenty flat washers (4), and ten cap screws (6).6. Remove five self-locking nuts (3), ten flat washers (2), five cap screws (1), and fender (7).4-46
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
