4-22 DATA PLATE AND REFLECTOR MAINTENANCE.

Figure 4-22. Identification/Transport on Data Plate and Reflector Replacement.

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
108

TM 9-6115-660-13&P INSTALLATION 1. Install lifting ring (8), flat washer (6), lock washer (5), and nut (4) on mounting plate (7) and torque to 315-347 lb. ft (420-470 N-m). 2. Install mounting plate (7), screws (1), flat washers (2), and self-locking nuts (3). 4-22 DATA PLATE AND REFLECTOR MAINTENANCE. This task covers: Replacement INITIAL SETUP Tools Equipment Conditions Tool Kit, General Mechanic’s Reference (item 1, appendix B) Drill, 1/4-inch (item 2, appendix B) Trailer handbrakes set, front support Drill, Twist, 3/16 (item 2, appendix B) leg/landing leg lowered, and rear Riveter, Blind Hand (item 5, appendix B) leveling-support jack lowered; paragraph 2-3.2.1. Materials/Parts Plate, Identification/Transportation Data Screws, Drive Rivets (item 3, appendix I) REPLACEMENT 1. REPLACE DATA PLATE. NOTE For PU-798 and PU-799 data plates, refer to trailer chassis TM 9-2330-202-14&P. For AN/MJQ-37 and AN/MJQ-38 data plates, refer to trailer chassis TM 9-2330-213-14&P. For PU-798A and PU-799A data plates, refer to trailer chassis TM 9-2330-392-14&P. a. Drill out rivets (4, figure 4-22) and remove data plate (3). b. Position data plate (3) on trailer and install rivets (4). 2. REPLACE REFLECTORS NOTE For replacement of reflectors on PU-798A and PU-799A, refer to TM 9-2330-392-14&P. a. Remove self-locking nuts (5), flat washers (6), screws (8), and reflector (7) from trailer (PU-798 and PU-799, and rear of AN/MJQ-37 and AN/MJQ-38 only). Change 2 4-43

Privacy Statement
Press Release
Contact