TM 9-6115-660-13&PREPAIRNOTERepair is limited to replacement of non-skid material (8). Refer to figure G-7, appendix G.INSTALLATION1.2.3.4.5.6.7.Loosely install fender (7), five screws (6), ten flat washers (5), and five self-locking nuts (4).Install and tighten four cap screws (3), eight flat washers (2), and four self-locking nuts (1).Tighten five self-locking nuts (4).NOTEIf replacing fender(s), fire extinguisher bracket, and/or data plate, and ground stud removedduring removal procedures must be reinstalled. If replacing roadside fender, perform steps4, 5, 6, and 7. If replacing curbside fender, perform step 4.Instill fire extinguisher bracket (paragraph 4-20).Install data plate (paragraph 4-22).Install ground stud (19), two internal tooth lock washers (17), lock washers (16), nuts (15), and grounddata plate (18).Install flat washer (14), ground wire (13), flat washer (12), nut (11), two flat washers (10), and wingnut (9).4-51
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
