Figure 2-7. Ground Rod and Slide Hammer.

TM-9-6115-659-13P Power Unit PU-732/M (NSN 6115-00-280-3082) MEP-118A 15 Kw 400 Hz Generator Set M200A1 2-Wheel 4-Tire Modified Trailer Manual
Page Navigation
45

TM 9-6115-659-13&P Figure 2-7. Ground Rod and Slide Hammer. a. Remove ground rod, grounding strap, and slide hammer (figure 2-7) from accessory box. Perform assembly steps (1) through (4). (1) (2) (3) (4) WARNING Impact disk must be tightened to end of threads on rod. Also, lock washer and nut must be tightened firmly against impact disk. Failure to observe this warning could result in severe personal injury ador death and damage to the equipment. NOTE The terminal lug supplied with the ground ground strap provided with power unit. rod is too small. Use additional Install impact disk (3) on rod (4). Tighten impact disk to end of threads on rod (4). Install lock washer (2) and nut (l). Tighten nut (1) and lock washer (2) securely against impact disk (3). If installed, remove nut (6). Position hammer (5) on rod (4). Install nut (6) and tighten to end of threads on rod (4). 2-32

Privacy Statement
Press Release
Contact