Table 5-3. Unit Remote Control Module Troubleshooting (Continued)

SECTION III. REMOTE CONTROL CABLE ASSEMBLY - TM-9-6115-604-12_430

Table 5-3. Unit Remote Control Module Troubleshooting (Continued) - TM-9-6115-604-12_432

TM-9-6115-604-12 Generator Set Diesel Engine Driven Tactical Skid Rtd. 60 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
414

ARMY TM 9-6115-60412 NAVY NAVFAC P-8-633-12 Table 5-3. Unit Remote Control Module Troubleshooting (Continued) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION NOTE To determine whether it is the remote control module or the generator set that is malfunctioning, operate or monitor the corresponding control or indicator on the generator set to see if the correct indication is obtained. If operation or indication is correct, the remote control module is, most probably, at fault. If the generator set still does not operate properly, the generator set is, most probably, faulty. Refer to Table 3-3 and Table 4-3 for troubleshooting procedures for the generator set. 1. ANY REMOTE CONTROL MODULE MOUNTED METER OR SWITCH IS NOT FUNCTIONING PROPERLY, BUT THE CORRESPONDING METER OR SWITCH MOUNTED ON THE GENERATOR SET IS FUNCTIONING PROPERLY. Test the remote control cable assembly in accordance with paragraph 5-4. If the remote control cable assembly is defective, it must be replaced. If the remote control cable assembly is not defective, proceed to the applicable malfunction. 2. GENERATOR SET DOES NOT START WHEN MASTER SWITCH S9R IS MOVED TO START POSITION. Test MASTER switch S9R in accordance with paragraph 5-9, step q. If the MASTER switch is defective it must be replaced. If the MASTER switch is not defective, troubleshoot generator set In accordance with Table 4-3. 3. FREQUENCY METER M101R READS INCORRECTLY. Disconnect cable to remote control module and test FREQUENCY meter M101R In accordance with paragraph 5-9, step c. If FREQUENCY meter is defective, It must be replaced. If FREQUENCY meter is not defective, refer to the next higher level of maintenance. NOTE Frequency meter and transducer are a matched set. 4. AC KILOVOLTS METER M101R DOES NOT INDICATE CORRECT VOLTAGE. Disconnect cable to remote control module and test the GEN/BUS VOLTMETER switch S112R in accordance with paragraph 5-9, step b. If GEN/BUS VOLTMETER switch is defective, it must be replaced. If GEN/BUS VOLTMETER switch is not defective, test AC KILOVOLTS meter in accordance with paragraph 5-9. If AC KILOVOLTS meter is defective, It must be replaced. If AC KILOVOLTS meter is not defective, refer to the next higher level of maintenance. 5-29

Privacy Statement
Press Release
Contact