Table 5-3. Unit Remote Control Module Troubleshooting (Continued)

Table 5-3. Unit Remote Control Module Troubleshooting (Continued) - TM-9-6115-604-12_433

APPENDIX A REFERENCES - TM-9-6115-604-12_435

TM-9-6115-604-12 Generator Set Diesel Engine Driven Tactical Skid Rtd. 60 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
417

ARMY TM 9-6115-604-12 NAVY NAVFAC P-8-633-12 Table 5-3. Unit Remote Control Module Troubleshooting (Continued) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 22. BREAKER CONTROL SWITCH DOES NOT WORK. Test switch in accordance with paragraph 5-9, step g. Replace switch. 23. AMMETER SELECTOR SWITCH DOES NOT WORK. Test switch In accordance with paragraph 5-9, step h. Replace switch. 24. SYNCHRONIZING LIGHTS DO NOT WORK. Test lamps, lamp holders, and resistors In accordance with paragraph 5-9, step h. Replace lamps, lamp holders, or resistors as needed. 25. SYNCHROSCOPE SWITCH DOES NOT WORK. Test switch In accordance with paragraph 5-9, step o. Replace switch. 26. OPEN/CLOSED (BREAKER POSITION) INDICATORS DO NOT WORK. Test lamps and lamp holders in accordance with paragraph 5-9, step m. Replace switch. 5-14. UNIT MAINTENANCE OF THE REMOTE CONTROL CABLE ASSEMBLY. Unit maintenance of the RCM cable assembly (34, Figure 5-1) is limited to testing of the cable assembly. a. Test (1) Disconnect the RCM cable assembly in accordance with paragraph 5-12. (2) Set a multimeter to RX1 scale and test RCM cable assembly. Check for isolation between adjacent conductors, and between any conductor and ground. Multimeter should read infinite resistance for each test. (3) Check each conductor for continuity from one plug connector to the other. Multimeter should read zero resistance from one end of any conductor to the other. (4) If tests fail to show Isolation or continuity, refer to the next higher level of maintenance for repair and overhaul of the defective RCM cable assembly. 5-32

Privacy Statement
Press Release
Contact