ARMY TM 9-6115-604-12NAVY NAVFAC P-8-633-12CHAPTER 4UNIT MAINTENANCESECTION I. SERVICE UPON RECEIPT OF EQUIPMENT4-1. INSPECTION UPON RECEIPT. Inspect for damage which may have occurred during shipment. Check for looseor missing hardware, fuses, or bulbs. Refer to Figure 4-1 and-a.InspectControlRoomCheck for'(1)Remote control module (RCM), (if procured) on floor, bolted to right wall.(2)Two headsets, extension cord and shorting plug in wall mounted box above RCM location.(3)Fire extinguisher on floor to left of control room door.(4)Schematic Lamination located In document compartment.(5)Racking handle located in bottom of cabinet B.b.InspectGeneratorCompartmentCheck for(1)Lifting kit two slings, on floor, beneath generatorNOTERemove slings from engine compartment during operation to avoid contact with fuel andlube oil that could cause deterioration of nylon fabric sling(2)Two ground clamps, inside tool box.(3)Circuit breaker ramps, channel mounted to the rear generator support beam.(4)Two ground cables, on floor, between conduit box and tool box.(5)Mufflers, standing upright on floor and bolt mounted, by means of a stowage angle, to the conduit box.(6)Lifting kit (four spreader bars), on floor, beneath switchgear(7)Four load cables, on floor, between conduit box and switchgear.(8)Station power cable assembly, on floor, between conduit box and switchgear(9)Reactive load and governor control assemblies, on floor, between conduit box and switchgear(10)RCM cable assembly (if procured), on floor, between conduit box and switchgear.c.InspectEngineCompartment. Check for:(1)Two fire extinguishers hanging next to air cleaners.(2)Auxiliary fuel hose assembly coiled and hanging from bracket behind radiator.(3)Three grounding rods clamp-mounted to skid base.(4)Two ground clamps in tool box.(5)Two blocking pins in tool box.4-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
