Figure 4-2. Grounding Generator set to a Driven Metal Rod

Figure 4-3. Grounding Generator Set to a Buried Metal Plate

TM-9-6115-604-12 Generator Set Diesel Engine Driven Tactical Skid Rtd. 60 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
188

ARMY TM 9-6115-604-12 NAVY NAVFAC P-8-633-12 DO NOT OPERATE THE GENERATOR SET UNLESS IT HAS BEEN PROPERLY GROUNDED. ELECTRICAL FAULTS (SUCH AS LEAKAGE PATHS) IN THE GENERA. TOR SET, FEEDER LINES OR LOAD EQUIPMENT CAN CAUSE INJURY OR DEATH BY ELECTROCUTION. STEP 1 INSERT GROUND CABLES INTO SLOTS IN GROUND TERMINAL STUDS AND TIGHTEN NUT. STEP 2 DRIVE GROUND RODS INTO GROUND UNTIL ROD PROTRUDES 6 INCHES (152mm) ABOVE SURFACE. STEP 3 CONNECT CLAMP AND GROUND CABLE TO EXPOSED GROUND ROD AND SECURE BY TIGHTENING NUTS. Figure 4-2. Grounding Generator set to a Driven Metal Rod 4-5

Privacy Statement
Press Release
Contact