PLATE AND SLEEVE ASSEMBLY.

Figure 4-50. Housing Assembly, Exploded View (Sheet 2 of 2)

Figure 4-51. Plate and Sleeve Assembly, Exploded View

TM-9-6115-464-12 Wrench Impact Hydraulic Model MV-12-140T Manual
Page Navigation
203

ARMY TM 9-6115-464-12 AIR FORCE TO 35C2-3-445-1 NAVY NAVFAC P-8-624-12 4-86 PLATE AND SLEEVE ASSEMBLY. a. Removal and Disassembly. (1) Remove screws (1, Figure 4-51) and Lockwashers (2) to remove plate and sleeve assembly. (2) Remove ring (3) and bushing (4); then remove nuts (5), screws (6) and retainer (7) to remove sleeve (8) with draw string (9) from plate (10). b. Cleaning and Inspection. (1) Clean plate and sleeve assembly with a dean, lint free cloth Iightly moistened with an approved solvent. (2) Visually inspect plate for cracks, dents, illegible markings, defective paint, ant other damage. (3) Inspect weather sleeve for cracks, deterioration, broken or missing drawstring, and other damage. (4) Check threaded parts for stripped or damaged threads. c. Installation. (1) Install plate (10, Figure 4-51) with drawstring (9), sleeve (8), retainer (7), screws (6), nuts (5), bush- ings (4), and ring (3). (2) Install plate and sleeve assembly with lockwashers (2), and screws (1). 4-87 LIFTING FRAME. Visually inspect lifting frame (Figure 1-4) for cracks, corrosion, damaged or missing lift- ing Clevis, insecure mounting hardware, and other damage. 4-88 SKID BASE ASSEMBLY. a. b. c. d. e. f. g. Visually inspect skid base assembly (Figure 1-4) for cracks, corrosion, and other damage. Check that bottom sheet drain holes are open. Inspect ground stud for stripped or otherwise damaged threads, corrosion, and other damage. Replace lost or broken terminal dip (Retainer, Safety Clip). For fabrication procedure, see Chapter 4, Section XVI Unit Maintenance of the Generator Electrical System, paragraph 4-74 Load Terminal Board Assembly. Inspect fuel tank for insecure mounting, cracks, leaks, and other damage. Check that fuel tank and engine crankcase drains are securely installed and not leaking. Test fuel level sensor as follows: (1) (2) (3) (4) (5) (6) Drain fuel tank assembly (paragraph 4-37). Disconnect electrical connector from fuel level sensor. Connect an ohmmeter or similar device between fuel level sensor casing and connector pin. Ohm- meter shall indicate 0.0 to 1.0 ohms resistance. Fill fuel tank with proper grade of fuel (paragraph 4-37). Ohmmeter shall indicate 27 ± 2 ohms resistance. Replace fuel level sensor if it fails to meet test requirements. Replace fuel level sensor as follows: (1) (2) (3) (4) (5) (6) Drain fuel tank assembly (paragraph 4-37). Disconnect electrical connector from fuel level sensor. Remove 5 attaching screws to remove fuel level sensor and gasket from fuel tank. Install replacement fuel level sensor and gasket and secure with 5 attaching screws. Connect electrical connector to fuel level sensor. Service fuel tank with proper grade of fuel (paragraph 4-37). 4-119

Privacy Statement
Press Release
Contact