ARMY TM 9-6115-464-12
AIR FORCE TO 35C2-3-445-1
NAVY NAVFAC P-8-624-12
c.
Replacement.
(1) Removal.
(a) Loosen adjustment screw (Figure 4-42) and remove cable from sleeve.
(b) Remove nut and lockwasher, screw, and clip.
(c) Remove nut and washer to remove manual speed control cable assembly and grommet.
(d) Do not remove screws, lockwashers and mounting bracket unless inspection revealed damage.
NOTE
See paragraph 4-17 for emergency conversion from tactical precise to tactical
utility and for reconfiguration back to tactical precise.
(2) Cleaning.
(a) Clean all metal manual speed control parts in an approved solvent and dry thoroughly.
(b) Clean boot on manual speed control knob with soap and water.
(3) Installation.
(a) If removed, install mounting bracket, (Figure 4-42) lockwashers, and screws.
(b) Install manual speed control cable assembly, grommmet, washer, and nut.
(c) Install dip, screw, lockwasher, and nut.
(d) Install cable onto sleeve and tighten adjustment screw.
Figure 4-42. Manual Speed Control, Exploded View
4-104
