ARMY TM 9-6115-464-12 AIR FORCE TO 35C2-3-445-1 NAVY  NAVFAC  P-8-624-12 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. Screw Lockwasher Screw and captive washer assy Cover plate Screw and captive washer assy Indicator  panel  assembly Nut Indicator  light  assembly Lens Lamp Base Nut Tooth  lockwasher Test  or  reset  switch Capacitor Positioning  washer Nut 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. Tooth  lockwasher Fuse  holder  assembly Cap Fuse Fuse  holder Panel Screw and captive washer assy Cover  plate  assy Screw and captive washer assy Screw Lockwasher Relay Component  board  assembly Cover  plate screw  and  captive  washer  assy Wiring  harness Housing Nut Figure   4-41.   Fault   Locating   Indicator,   Exploded   View   (Sheet   2   of   2) 4 - 6 5    M A N U A L    S P E E D    CO N T R O L . a. Inspection. (1)   Inspect   manual   speed   control   knob   (Figure   4-42)   for   cracks,   beaks,   and   other   damage   and   condition   of boot. (2)   Inspect   Control   cable   assembly   for   corrosion,   pinched,   frayed,   or   otherwise   damaged   cable,   pinched or    damaged    housing,    insecure    mounting,    and    stripped    or    otherwise    damaged    adjusting    threads. b .     T e s t i n g . ( 1) (2) (3) (4) (5) (6) On   precise   models   of   the   generator   set,   the   manual   speed   control   must   be   connected   as   follows. (a)   Push   manual   speed   control   all   the   way   in. (b)   Insert   manual   speed   control   cable   through   sleeve   of   fuel   injection   pump   manual   throttle   control   arm (Figure    4-42). (c)    Install    and    tighten    adjustment    screw. (d)   Install   lockwire. Check   manual   speed   control   for   unrestricted   movement. Refer   to   paragraph   2-6   and   start   the   generator   set. Use   the   manual   speed   control   to   set   generator   output   frequency. Rotate   the   control   knob   90   degrees.   Frequency   change   shall   not   exceed   1   percent   for   a   90   degree rotation   (0.6   Hz   for   50/60   Hz   generator   sets   and   4   Hz   for   400   Hz   generator   sets). Replace   manual   speed   control   if   it   fails   any   of   the   above   tests   or   inspections. 4 - 1 0 3