TM5-6115-634-14&P
NAVFAC P-8-647-14&P
T0-35C2-3-445-14
TM-6115-14&P/1
5-25. TEST SPECIAL RELAY ASSEMBLY (cont)
TEST
TEST SPECIAL RELAY ASSEMBLY
NOTE
When a component or assembly
fails during the following test
procedures, refer the special
relay assembly to higher level
maintenance.
NOTE
Components shown removed are
for identification and relative
locations only. Actual removal
is not required.
a.
Use an ohmmeter to test poten-
tiometer (7) as follows:
(1)
(2)
(3)
Connect ohmmeter leads
between wiper terminal and
either outer terminal.
Rotate adjustment at an
even rate from full
counter-clockwise to full
clockwise.
Meter indica-
tion should change at even
rate from O to 12 ohms.
Refer to wire run list and
test wiring harness wires
for continuity.
5-44
