ARMY TM 5-6115-633-14&P
Working under trailer, install one flat washer (10) and one nut (11) on each of 16 mounting
(9)
rail screws (9) and tighten.
(10)
Position one composite light (5) on each rear mounting bracket (8) and secure each light
with two screws (6) and two Iockwashers (7).
(11)
Working under trailer, connect one composite light cable assembly (3) to each composite
light (5) by plugging four cable assembly connectors into four composite light connectors
(4). Plug four connectors at opposite end of each cable assembly into four connectors (1)
on trailer main wiring harness (2).
(12)
Install both generator sets (paragraph 5-7, b.).
(13)
Install switch box (paragraph 4-24, b.).
(14)
Install accessory box (paragraph 4-19, b.).
Install six bows (paragraph 3-11, b(2)).
(15)
(16)
Install fitted cover (paragraph 3-11, a(2)).
5-4. Fitted Cover Repair. Repairs to the fitted cover shall be made in accordance with FM 10-16,
Fabric Repairing.
5-5. Accessory Box Repair. (See figure 5-4.) The accessory box is repaired by replacing the hasp,
the catches and the footmans loops, as required. The box itself maybe straightened, welded, and
repainted. If required, repaint in accordance with MIL-T-704, Type F, color Green, No. 383 of MIL-
C-46168.
a. Catch and Hasp Replacement.
(1) Grind off or drill out solid rivets (1) securing catch or hasp (2) to accessory box (3).
(2) Position new catch or hasp (2) on accessory box and secure with solid rivets (1).
(3) Touch up with paint as required.
b. Footmans Loop Replacement.
(1) Remove two screws (4), two flat washers (5), and two self-locking nuts (6) securing
footmans loop (7) to accessory box lid.
(2) Position new footmans loop (7) on accessory box (3) and secure with two screws (4) two
washers (5), and two self-locking nuts (6).
5-6. Marking. (See figure 5-5.) The power plant four-digit registration number, preceded by the
prefix "VC" and the words "U.S. ARMY, " is marked in three places on the trailer. Marking is done in
accordance with MIL-STD-642. On the fender, over each wheel, "T.P.50 PSI" is marked in 1.00
.12 inch high characters in accordance with MIL-STD-130. On the switch box, "GEN 1", "GEN 2" and
`OFF" are marked on the cover at their respective switch lever positions. On the 5-wire switch box
only, "E1" and "E2" are marked next to their respective ground terminal studs. Figure 5-5 shows the
approximate location of markings on the power plant. If required, touch-up painting of the base color
shall be done in accordance with MIL-T-704, Type F, color Green, No. 383 of MIL-C-46168.
5-7