TM 5-6115-593-34
NAVFAC P-8-631-34
TO-35C2-3-463-2
Also remove screws (30), washers (32), and nuts (31) from end of panel (36).
(12)
Remove lower side panel (29) from base assembly by removing screws (25), washers (28), and nuts (27);
and one screw (26), washer (28), and nut (27).
(13)
Remove upper side panel (36) from support frame by removing screws (33), washers (35) and nuts (34).
f.
Front. Refer to figure 15-18 and remove as follows:
(1)
Remove screws (4), nuts (5), and chain assemblies (6). Remove shutter (8) and grille (7) from support
frame (13) by removing screws (1), nuts (2), and washers (3 and 33).
(2)
Remove support frame (13) by removing seven screws (9) and washers (11 and 12) from top flange and
six screws (9), and washers (11 and 12) from bottom flange; and remove seven screws (9), washers (11
and 12), and nuts (10) from each side flange.
(3)
Remove enclosure panel (30) from base assembly by removing screws (28) and washers (29), and replace
hardware in base assembly.
(4)
Remove upper panel (17) by removing screws (14), nuts (15), and washers (16).
(5)
Remove right-hand panel (23) from right side post by removing screws (18), and washers (20); and from
base assembly by removing screws (21) and washers (22).
(6)
Remove left-hand panel (27) from left side post by removing screws (24), and washers (26); and from base
assembly by removing screws (21) and (22).
g.
Right Side. Refer to figure 1'5-17 and remove as follows.
(1)
Remove corner post (57) by removing screws (52) and nuts (53); and screws (55) and washers (56) which
secure the post to the support frame.
(2)
Remove access doors (8) by first opening loop ends on door holder rod (18), then removing rod, screws
(1), washers (2), and nuts (3).
(3)
Remove door and shutter assemblies (19) by first opening loop ends on door holder rods (18), then
removing rod. Remove screws (14), washers (15), nuts (16), and clamps (17).
(4)
Remove bottom side panel (24) from support frame by removing screws (20), washers (22), nuts (21) and
clamps (23).
(5)
Remove top side panel (28) from support frame by removing screws (25), washers (27), and nuts (26).
(6)
Remove side panel (48) from support frame by removing screws (46) and nuts (47). Also remove screws
(29), washers (31), and nuts (30) from lower side panel (35).
(7)
Remove side panel (45) from support frame by removing screws (43) and nuts (44). Also remove screws
(36), washers (38), and nuts (37) from panel (42).
(8)
Similarly, remove side panel (51) by removing screws (29), washers (31), nuts (30), and clamps (31A) from
panel (35).
(9)
Remove side panel (54) from support frame by removing screws (52) and nuts (53). Also remove screws
(36), washers (38), and nuts (37) from upper side panel (42).
(10)
Remove lower side panel (35) from base assembly by removing screws (32), washers (34), and
15-39
