TM 5-6115-593-34
NAVFAC P-8-631-34
TO-35C2-3-463-2
posts (36 and 39). Remove screws (17), washers (18), and nuts (19) which secure panel (12) to panel (20).
Remove screws (13) which secure left-hand panel (15) to bottom panel (24). Remove screws around fuel
tank filler neck area. Remove screws (13) left-hand panel (15) which secure panel (20). Remove screws
(25), washers (26), and nuts (48); and screws (27) and washers (28) securing panel (29) to base assembly.
(5)
Remove right-hand panel (12) from corner post (36) and upper panel (33) by removing screws (10).
(6)
Similarly, remove left-hand panel (15) from corner post (39) and upper panel (33) by removing screws
(13).
(7)
Disassemble panels (20, 24 and 29). Remove screws (17), and washers (18) which secure panel (20) to
panel (24). Remove screws (21), washers (22), and nuts (23) which secure panel (24) to panel (29).
(8)
Remove upper panel (33) from corner posts (36 and 39), by removing screws (30), washers (32), and nuts
(31).
(9)
Remove corner post (36) from support frame by removing screws (34) and washers (35).
(10)
Similarly, remove other corner post (39) by, removing screws (37) and washers (38).
e.
Left Side. Refer to figure 15-19 and remove as follows:
(1)
Remove corner post (51) by removing screws (37), and nuts (38); and screws (49) and washers (50) which
secure the post to the support frame.
(2)
Remove access door (7) by first opening loop ends on door holder rod (8) and then removing rod, screws
(1), and washers (3), and nuts (4).
(3)
Similarly, remove the other access door (7) by first opening loop ends on door holder rod (8) and then
removing rod, screws (1), washers (3), and nuts (4).
(4)
Remove door and shutter assembly (9) by first opening loop ends on door holder (8) and then removing
rod, screws (1), washers (3), nuts (4), and clamps (5).
(5)
Similarly, remove the other door and shutter assembly by first opening loop ends on door holder rod (8),
then removing rod, screws (1), washers (3), nuts (4), and clamps (5).
(6)
Remove bottom side panel (17) by removing screws (14), washers (16), nuts (15), and clamps (16A).
(7)
Remove top side panel (21) by removing screws (18), washers (20), and nuts (19).
(8)
Remove side panel (45) by removing screws (43) and nuts (44) from support frame, and remove screws
(22), washers (24), and nuts (23) from panel (29).
(9)
Remove side panel (48) from support frame by removing screws (46) and nuts (47). Remove screws (30),
washers (32), and nuts (31) from panel (36).
(10)
Similarly, remove side panel (39) from support frame by removing screws (40) and nuts (38). Also remove
screws (22), clamps (53), washers (24), and nuts (23) from end of panel (29).
(11)
Remove side panel (42) from support frame by removing screws (40) and nuts (41).
15-38
