TM 5-6115-593-34
NAVFAC P-8-631-34
TO-35C2-3-463-2
b.
Shutter Assembly. See figure 15-22 and remove shutter assembly as follows:
(1)
Remove grille (7), (figure 15-18) by removing hardware, (1, 2, 3, 33). Open draincock (33, figure 7-1), and
drain coolant into suitable container.
(2)
Disconnect hoses (18, 19, 25, Figure 15-22) from actuators (12).
(3)
Remove two hose clamps (24) and replace the hardware that secured them. Remove hoses (23 and 19)
and connectors (21). Place plug after removing connectors (21) in radiator (86), (figure 7-1).
(4)
Remove shutter assembly (8) figure 15-18, by removing screws (1), nuts (2), washers (33) and support (13)
with screws (9), washers (11, 12) and nut (10).
c.
Top. Refer to figure 15-21 and remove housing kit top as follows:
(1)
Remove strip (4) by removing screws (1), washers (3), and nuts (2); and screws (14) and nuts (15).
(2)
Similarly, remove strip (27) by removing screws (24), washers (26), and nuts (25); and screws (28) and
nuts (29).
(3)
Remove panel (20) by removing screws (17), washers (19), and nuts (18).
(4)
Referring to detail A in figure 15-21, remove the eight screws and washers from the muffler support
brackets as shown.
NOTE
Retain screws and washers. The will be replaced later on.
(5)
Remove screws (21) figure 5-21 and nuts (22) attaching panel (23) to support frame. Now carefully lift
both muffler assemblies (just enough to allow panel to slip out) and remove panel (23)
(6)
Replace the eight screws and washers, previously removed, on the muffler assembly brackets.
(7)
Remove panel (16) by removing screws (14) and nuts (15).
(8)
Remove panel (7) by removing screws (5) and washers (6).
(9)
If so desired, remove radiator access door (10) by removing screws (8), nuts (9), and seal (11). Remove
stud receptacle (13) and its stud and pin by removing rivets (12).
(10)
Remove panel (30) by removing screws (28) and nuts (29).
(11)
Remove panel (34) by removing screws (31) and washers (32).
d.
Rear. Refer to figure 15-20 and remove as follows:
(1)
Disassemble cover and sleeve assembly by removing plate (47) from housing by removing screws (45)
and nuts (46). Disassemble sleeve (41), bushing (40), and retainer plate (44) by removing screws (42) and
nuts (43).
(2)
Remove access door (3) by first opening loop ends on door holder rod (6) and then removing rod and
screws (1) and nuts (2).
(3)
Remove access door (9) by first opening loop ends on door holder (6) and then removing rod, screws (4)
and nuts (5).
(4).
Remove all three panels (20, 24, and 29) as a unit. Remove screws (17), washers (18), and nuts (19)
which secure panel (12) to panel (24). Remove screws (21), washers (22) and nuts (23) which secure
panel (24) at each end to corner
15-37
