TM5-6115-593-34
NAVFAC P-8-631-34
TO-35C2-3-463-2
LEGEND
1.
Connecting rod assy
6.
Bushing
11. Piston
2. Nut
7. Connecting Rod
12. Ring set
3. Washer
8.
Piston assy
13. Ring
4. Bolt
9. Ring
14. Ring
5. Bearing
10. Pin
15. Ring
16. Ring
Figure 13-47. Piston and Connecting Rod, Exploded View
block using a cylinder liner puller and a puller
bridge.
b.
Inspection. Proceed as follows:
(1) Cylinder liners.
(a) Check for cracks just under top flange,
at bottom of liner, and above top seal
ring groove.
(b) Discard and replace any liner with
excessive corrosion or erosion and pits
1/16 inch (1.59 mm) deep or more, or if
dents, pitting, or fretting on underside of
liner flange cannot be removed by
lapping.
(c) Check worn liners with dial bore gauge.
Replace if worn more than worn limit
specified in Chapter 1.
(d) Deglaze cylinder liner walls. Used liners
only.
(2) Connecting rod bearing.
(a) Gauge shell with ballpoint micrometer,
dial
indicator
thickness
gauge,
or
comparator. Discard shells if they are
worn more than
13-90
