TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Table 1-2.  Repair and Replacement Standards - Continued NEW MINIMUM NEW MAXIMUM PART OR LOCATION WORN LIMIT INCH (mm) INCH (mm) Crankshaft thrust ring Thickness * 0.307 0.317 (7.80) (8.05) Crankshaft end clearance 0.026 0.006 0.013 (Installed) (0.66) (0.15) (0.33) Connecting Rod Crankpin bore 4.0018 4.0028 Inside diameter )101.646) (101.671) Out-of-round 0.001 (0.02) Center-to-center-length 11.998 12.050 (304.75) (304.80) NOTE *Add 0.003 inch (0.08 mm) ring gap to new maximum limit  for  0.001  inch  (0.03  mm)  wear  in  cylinder  liner wall. Piston pin bushing Inside diameter 2.0025 2.001 2.0015 (50.863) (50.82) (50.838) Connecting rod Alignment 0.008 without bushing (0.20) Alignment 0.004 with bushing (0.10) Twist 0.020 without bushing (0.51) Twist 0.010 with bushing (0.25) Bolt pilot 0.6242 0.6245 0.625 (15.855) (15.862) (15.87) Rod bolt hole 0.6249 0.6243 0.6248 (15.872) (15.857) (15.867) Connecting rod bolt Outside diameter 0.540 0.541 0.545 (13.72) (13.74) (13.84) Piston and Piston Rings Skirt diameter at 70xF 5.483 5.487 5.488 (21xC) 139.27) (139.37) (139.39) 1-9