TM5-6115-593-34
NAVFAC P-8-631-34
TO-35C2-3-463-2
Table 1-2. Repair and Replacement Standards - Continued
NEW MINIMUM
NEW MAXIMUM
PART OR LOCATION
WORN LIMIT
INCH (mm)
INCH (mm)
TAPPETS (Cont'd)
Roller inside diameter
0.505
0.503
0.504
(12.83)
(12.78)
(12.80)
Roller pin outside
0.4985
0.4995
0.500
diameter
(12.662)
(12.69)
(12.70)
Roller side clearance
0.027
0.008
0.022
(0.69)
(0.20)
(0.56)
Roller concentricity
.002
(0.05)
Roller squareness
.004
(0.10)
FAN HUB
End Clearance
0.001
0.007
(0.03)
(0.18)
DRIVE UNITS
Fuel Pump, Compressor
1.3205
1.316
1.319
Bushings
(33.541)
33.43)
(33.50)
Generator Bushing
1.3205
1.316
1.319
(33.541)
(33.43)
(33.50)
WATER PUMP WITHOUT IDLER
Impeller to shaft
.0012
0.0012
0.0026
press fit
(0.031)
(0.031)
(0.066)
Pulley to shaft
0.007
0.007
0.0021
press fit
(0.018)
(0.018)
(0.53)
Impeller to body
0.020
0.031
(0.51)
(0.79)
Impeller to cover
(0.51)
(1.02)
WATER PUMP WITH IDLER
Impeller to shaft
0.0012
0.0012
0.0026
press fit
(0.031)
(0.031)
(0.066)
Pulley to shaft
0.001
0.001
0.0025
press fit
(0.025)
(0.025
(0.064)
Impeller to body
(0.020
(0.031
clearance
(0.58)
(0.79)
Bearing bore on body
1.810
1.8085
1.8095
(45.97)
(45.94)
(45.96)
Seal bushing bore
1.8755
1.8735
1.8745
on body
(47.64)
(47.59)
(47.61)
Bearing bore on
1.810
1.8085
1.8095
idler pulley
(45.97)
(45.94)
(45.96)
1-13